Autofiber Sponge Case Of Thin [Saver Applicator Half/Half] Microfiber Coating Applicator Sponge with Plastic Barrier (One Side Suede, One Side Terry) - 216 per case
Autofiber Bulk Sponge FULL CASE Thin [Saver Applicator Half/Half] Microfiber Coating Applicator Sponge with Plastic Barrier (One Side Suede, One Side Terry) - 216 per case
Autofiber Sponge Case Of Thin [Saver Applicator Half/Half] Microfiber Coating Applicator Sponge with Plastic Barrier (One Side Suede, One Side Terry) - 216 per case
Autofiber Sponge Case Of Thin [Saver Applicator Half/Half] Microfiber Coating Applicator Sponge with Plastic Barrier (One Side Suede, One Side Terry) - 216 per case

FULL CASE Thin [Saver Applicator Half/Half] Microfiber Coating Applicator Sponge with Plastic Barrier (One Side Suede, One Side Terry) - 216 per case

Designer: Autofiber Case

$ 367.20
$ 367.20
$ 432.00
Sold Out
SKU SSTX101GYB-CASE-AF
Case Qty: units
Inner Pack Qty: units
Size:

GSM is "grams per square meter". It represents the weight of the material one meter square. Larger numbers are heavier, with more microfiber and more absorbent.

Blend is the ratio of polyester to polyamide. Higher ratio of polyamide is usually softer and more absorbent.

Material is the type of weave and physical feel of the surface yarn.

Examples: Terry, Suede, Waffle-Weave, Twist.

Made in
Saver Applicator Thin Microfiber Coating Sponge by Autofiber

 

 One side Suede, One Side Terry - Half & Half

The main complaint about microfiber applicators is the that they absorb too much product. Over the past few years, as expensive coatings have taken over the industry, the complain has only grown. Microfiber applicators make coating product application easier, quicker and more efficient, but coatings typically have a lower viscosity (not as thick - flow easier) so they soak through the microfiber to the sponge, wasting valuable product.

Our solution to this problem is the [Saver Applicator] wax sponge. We have added a layer of a hydrophobic material between the microfiber and sponge. This prevents excess coating product from soaking through the microfiber into the sponge. It also limits excess product buildup which can become gummy and tacky as the coating begins to cure.


These terry cloth applicator sponges are two-tone only to differentiate them from the standard microfiber applicators, which don’t have the product saver hydrophobic layer. The two sides function exactly the same.

These car wax applicator sponges are available in 3 sizes. If you're looking for something thicker, see our Thick Microfiber Applicator Sponge Pads.

 

These are the Thin - 5" x 3.5" x 1"


 

 

Article: Learn More about Ceramic Coating Applicators and Towels